MORI SEIKI : THE FINAL STAGES OF THE REBUILD

What Our Rebuild Department Can Accomplish For You:  NuBUILD BY ROSSI

---

      Today the Mori Seiki moves into the final phase of its rebuild process. We are proud to say that the machine that sat under an awning in the elements is successfully running today. Pictured on the left is the installation of the X axis Ball Screw.  

There was .002 of lost motion detected in the movement of the axis.  Upon removal of the Ball Screw for inspection we found that the mounting plate had been damaged.  (See Below)

      What did we do in that case?  In our machine shop we manufactured a new plate, cleaned and re-packed the Ball Screw support bearings. (pictured below)

     While the Ball Screw was out of the machine, we used that time to send the I/O board out for repair.  In our troubleshooting, we discovered issues with the control on power up.  Below is a picture of the I/O board installed in the machine.  All of the functions are operational. 

---